Installation guide

User Interface Devices Crestron Adagio Entertainment System

2 • Adagio Entertainment System: User Interface Devices Out-Of-The Box Functionality Guide – DOC. 6493A

Using the APAD Wall Mount Controller

With an APAD installed in a room, a user can select and control sources that are

connected to the Adagio Entertainment System (AES), Adagio Media System

(AMS), or Adagio Audio Distribution System (AADS) as well as control the volume

in the room.

In its default OOTBF configuration, the APAD performs functions similar to the

operation of the AES, AMS, or AADS front panel controls.

AM/FM Tuner Status Screen

Other Commands Screen

Tone Controls Screen

Basic Settings

The tuner status screen shown to the left is a typical default display for the room

where the APAD is located. Set the basic room parameters as follows.

• Press the tuner status screen’s Other soft button to display the Rooms,

Tools, and Groups soft buttons, as shown to the left.

• Press Rooms to select another room to control. (Refer to

“Selecting/Controlling Rooms” on page 6.)

 Press Groups to display the list of room groups. Use the Nav Wheel to

scroll through the list; and press the soft button to the right of the Nav

Wheel (the Nav Wheel soft button) to turn a group on or off.

 Press Tools to display the tone controls screen. Press the Bass and

Treble soft buttons to enable adjustment of those settings. Press More

and then press the Bal or Loud soft button to enable adjustment of the

balance or the loudness settings. Use the Nav Wheel to adjust the bass,

treble, and balance levels; enter the selected setting by pressing the

Nav Wheel soft button. Use the On and Off soft buttons to turn the

loudness function on (default) and off.

 Press and hold the Tools soft button for approximately five seconds to

display the extended parameter adjustment screen. Use the Nav Wheel

to make the adjustments; press the Nav Wheel soft button to enter the

setting. Press the MinV soft button to adjust the room minimum

volume setting between 0% and 30%. Press the MaxV soft button to