User's Manual

Single/Dual-Channel Wireless Mic Receiver Crestron MP-FS-RX1/RX2
Operation
Basic Procedures
Before beginning, ensure that the MP-FS-RX1/RX2 receiver is installed and
connected as instructed in “Setup” on page 8, that power is on (the green LED is on),
that line level audio is supplied from a DVD player, a laptop computer, or other
device, and that the MP-FSMIC microphone has been fully charged.
Microphone Button/LED Functions
During the following verification procedures, refer to the illustration above.
Pair Microphone with Receiver
1. Hold the MP-FSMIC ON button until the mic Status LED rapidly flashes green.
2. The mic will begin pairing with the receiver. Make sure the mic has line of sight
proximity to the MP-FSIR. When pairing is complete, the Status LED will
slowly blink green. Time to pair is typically between five and ten seconds.
The mic must be turned off and turned on again to pair to another receiver.
Mute and Volume Adjustments
1. Press the MUTE button to mute the mic (observe the blink pattern); press it
again to un-mute. When muted, the mic automatically turns off after two
minutes.
2. When the mic is not muted, the VOL button can be used to adjust the mic
volume.
3. When the mic is muted, the VOL button adjusts the line level audio volume.
4. Line volume is automatically “ducked” (reduced) when the user talks into the
mic.
5. Hold the MUTE button for five seconds to turn off the mic (turns off
automatically if muted for two minutes, or when placed in the charger.)
6. If the mic loses sight of the MP-FSIR for seven seconds (time is configurable),
the mic will automatically mute (turns off automatically if muted for two
minutes).
7. If RF link is lost for 10 seconds, mic turns off.
Emergency Trigger
Hold the ALERT button for eight seconds (time is configurable) to generate two
beeps from the speakers and close the alert relay contacts until the button is released.
10 • Single/Dual-Channel Wireless Mic Receiver: MP-FS-RX1/RX2 Operations & Installation Guide – DOC. 7164A