User Manual

InfiNET EX TableTop Controller Crestron HTT-B10EX
10 • infiNET EX TableTop Controller: HTT-B10EX Operations Guide – DOC. 6995
Setup
Prior to using the HTT-B10EX as part of a Crestron system, it must be configured
for use on an infiNET EX network.
HTT-B10EX Button Reference
Button #1:
Enables/Disables
Manner Mode
LED #8:
Indicates infiNET EX
link status
1
2
3 4
5
6
7 8
9
10
Joining an infiNET EX Network
Before an HTT-B10EX can be used in a lighting system, it must first join an
infiNET EX network by being acquired by an infiNET EX gateway.
NOTE: An HTT-B10EX can be acquired by only one gateway.
To acquire an HTT-B10EX, perform the following:
1. Put the infiNET EX gateway into Acquire mode from the unit itself or from
Crestron Toolbox, as described in its manual, available at
www.crestron.com/manuals.
NOTE: In an environment where multiple gateways are installed, only one
gateway should be in the Acquire mode at a time.
2. Place the HTT-B10EX into Acquire mode by doing the following:
a. Tap either the left or right top button three times then press and hold it
down (tap-tap-tap-press+hold) until the top LED on the device flashes
once (this can take up to 10 seconds).
b. Release the button to start the acquire process. The top LED blinks
slowly to show that the device is actively scanning the infiNET EX
network.
• The device is acquired when the LED stops blinking.
• If the acquire process fails, the LED flashes rapidly. If the device is
on battery power, the LEDs stop flashing after 5 seconds.
3. Take the infiNET EX gateway out of Acquire mode from the unit itself or
from Crestron Toolbox, as described in the latest version of its manual.