User Manual

InfiNET EX TableTop Controller Crestron HTT-B10EX
8 • infiNET EX TableTop Controller: HTT-B10EX Operations Guide – DOC. 6995
Setup
Identity Code
NOTE: The latest software can be downloaded at www.crestron.com/software.
Every HTT-B10EX communicating via RF with a Crestron control system through a
wireless gateway requires a unique RF ID. The RF ID is a 2-digit hexadecimal
number that can range from 03 to 6C. The RF ID of the unit, set using Crestron
Toolbox™, must match the RF ID specified in the SIMPL Windows program.
When setting the RF ID, consider the following:
• The RF ID of each unit must match an ID code specified in the SIMPL
Windows or SystemBuilder™ program.
• Each network device on the same gateway must have a unique RF ID.
For more details, refer to the Crestron Toolbox help file.
Button Installation
The HTT-B10EX is shipped with 10 blank buttons (two columns of five buttons
each). To replace one or both button columns, follow this procedure:
1. Disconnect the 12 volt power pack (if connected) and remove the batteries.
2. Remove the four Phillips screws from the four corners on the bottom of the
unit.
3. Remove the faceplate from the front of the unit.
4. Remove the old button column(s) and replace with the new one(s), making
sure the column is seated in the two small holes on the side. No screws are
required.
5. Replace the faceplate on the front of the unit.
6. Replace the four Phillips screws on the bottom of the unit.
7. Reinstall batteries and reconnect 12 volt power pack.