Operations Guide

This document was prepared and written by the Technical Documentation department at:
Crestron Electronics, Inc.
15 Volvo Drive
Rockleigh, NJ 07647
1-888-CRESTRON
Regulatory Compliance
Federal Communications Commission (FCC) Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions:
(1) This device may not cause harmful interference and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CAUTION: Cha
nges or modifications not expressly approved by the manufacturer responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This e
quipment has been tested and found to comply with the limits for a Class B device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more if the following measures:
• Reorient
or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
ISED Canada (IC) Compliance Statement
This device contains license-exempt transmitter/receiver that comply with Innovation, Science and Economic
Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device
must accept any interference, including interference that may cause undesired operation of the
device.
To satisfy RF exposure requirements, this device and its antenna must operate with a separation distance of at
least 20 centimeters from all persons and must not be colocated or operating in conjunction with any other
antenna or transmitter.
Déclaration de conformité à ISDE Canada (IC) Cet appareil contient un émetteur / récepteur exempt de licence
conforme aux RSS (ou aux RSS) de Innovation, Sciences et Développement économique Canada. Le
fonctionnement est soumis aux deux conditions suivantes:
1.Cet appareil ne doit pas causer d'interférences, et2.Cet appareil doit accepter toutes les interférences, y compris
celles pouvant entraîner un fonctionnement non souhaité du dispositif.
Pour satisfaire aux exigences en matière d'exposition aux radiofréquences, cet appareil et son antenne doivent
fonctionner à une distance de séparation d'au moins 20 centimètres de toute personne et ne doivent pas être situés
dans un même lieu ni être utilisés avec toute autre antenne ou émetteur.
Tout
All br
and names, product names and trademarks are the property of their respective owners.