Operations Guide

Crestron CWD7712 Two-Way RF Transceiver Module
Operations Guide - DOC. 7019A Two-Way RF Transceiver Module: CWD7712 • 5
Documentation
The OEM integrator has to be aware not to provide information to the end user regarding how to
install
or remove this RF module in the users manual of the end product.
The users manual for OEM integrators must include the following information in a prominent location
IMPORTANT NOTE: To comply with ISED
CANADA and FCC RF exposure
compliance requirements, the antenna used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.
REMARQUE IMPORTANTE: Pour être conforme aux exigences de conformité d’ISED CANADA et
de la FCC en matière d’exposition aux radiofréquences, l’antenne utilisée pour cet émetteur doit
être installée de manière à assurer une distance de séparation d’au moins 20 cm de toutes les
personnes. toute autre antenne ou émetteur.
FCC Warning:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.—Consult the dealer or an experienced radio/TV technician for help.
Please note that any modifications to the device software or configuration, including but not limited to
the init file(s), can cause device performance to vary beyond the scope of the currently referenced FCC
authorization. Accordingly, if any user modifications are sought to be made to the device software or
configuration, the user may be required to independently seek fresh FCC and other regulatory
authorizations as relevant prior to distributing or marketing the devices or products incorporating the
same.