Operations Guide

Two-Way RF Transceiver Module Crestron CWD7712
4 • Two-Way RF Transceiver Module: CWD7712 Operations Guide - DOC. 7019A
Setup
Hardware Hookup
Refer to the hookup diagram below, which shows the connections made to the module. Complete the
connections in any order.
NOTE: To prevent unit-to-unit RF interference, multiple modules operating at the same frequencies
should not be installed within three to five feet of each other.
Host
+4V
Control
Labeling
Federal Communications Commission FCC
If the FCC identification number is not visible when the module is installed inside another device, then
the outside of the device into which the module is installed must also display a label referring to the
enclosed module. This exterior label can use wording such as the following: “Contains Transmitter
Module FCC ID: EROCWD7712” or “Contains FCC ID: EROCWD7712.” Any similar wording that
expresses the same meaning may be used.
ISED Canada (IC)
If the IC identification number is not visible when the module is installed inside another device, then
the outside of the device into which the module is installed must also display a label referring to the
enclosed module. This exterior label can use wording such as the following: “Contains Transmitter
Module IC: 5683C-CWD7712” or “Contains IC: 5683C-CWD7712.” Any similar wording that
expresses the same meaning may be used.
Si le numéro d'identification du CI n'est pas visible lorsque le module est installé dans un autre
appareil, l'extérieur de l'appareil dans lequel le module est installé doit également afficher une étiquette
faisant référence au module inclus. Cette étiquette extérieure peut utiliser les libellés suivants:
«Contient le module de transmetteur IC: 5683C-CWD7712» ou «Contient le IC: 5683C-CWD7712».
Tout libellé similaire exprimant le même sens peut être utilisé.