User Manual

Crestron MNET-CWD1012 Two-Way RF Transceiver Module
Hardware Guide - DOC. 6351 Two-Way RF Transceiver Module: MNET-CWD1012 • 5
minimum distance 20cm between the radiator & your body. This transmitter must
not be co-located or operating in conjunction with any other antenna or transmitter.
This device is intended only for OEM integrators under the following
conditions:
1. The antenna must be installed such that 20 cm is maintained between the
antenna and users, and
2. The transmitter module may not be co-located with any other transmitter or
antenna.
As long as the two conditions above are met, further transmitter test will not be
required. However, the OEM integrator is still responsible for testing their end-
product for any additional compliance requirements required with this module
installed (for example, digital device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions cannot be met (for
example certain laptop configurations or co-location with another transmitter), then
the FCC authorization is no longer considered valid and the FCC ID cannot be used
on the final product. In these circumstances, the OEM integrator will be responsible
for reevaluating the end product (including the transmitter) and obtaining a separate
FCC authorization.
Setup
Hardware Hookup
Refer to the hookup diagram below, which shows the connections made to the
module. Complete the connections in any order.
NOTE: To prevent unit-to-unit RF interference, multiple modules operating at the
same frequencies should not be installed within three to five feet of each other.
Hookup Connections for MNET-CWD1012
POWER-I/O:
PROVIDES POWER AND
SYSTEM INTERFACE
ANTENNA:
TRANSMITS AND
RECEIVES RF SIGNALS
For more information on these connectors, refer to “Ports” on page 3.
Antenna Orientation
The module is provided with a dipole antenna that has a 90 degree-adjustable mount.
This antenna shall be oriented such that the antenna is in a vertical orientation when
the device is mounted for use.