User Manual

Two-Way RF Transceiver Module Crestron MNET-CWD1012
6 • Two-Way RF Transceiver Module: MNET-CWD1012 Hardware Guide - DOC. 6137
Mounting
The module has four 0.215” diameter holes for screws that can be used to secure the
module to an enclosure or other printed circuit board (PCB).
This module is authorized only for use in device where the antenna may be installed
such that 20 cm may be maintained between the antenna and users.
End Product Labeling
The final end product must be labeled in a visible area with the following: “Contains
FCC ID: EROCWD1012 .
Documentation
The OEM integrator has to be aware not to provide information to the end user
regarding how to install or remove this RF module in the users manual of the end
product which integrate this module.
The users manual for OEM integrators must include the following information in a
prominent location
“IMPORTANT NOTE: To comply with FCC RF exposure
compliance requirements, the antenna used for this transmitter
must be installed to provide a separation distance of at least 20
cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.”
The users manual for OEM integrators device must include the following
information in a prominent location:
“IMPORTANT NOTE: The antenna’s adjustable mount
must be manipulated such that the antenna is placed in a
vertical orientation when the device is installed.”