User Manual

CLW-DIM1RF, DIMS1RF, & SLVD1RF(W/A/B)
Physical Description
Physical view of CLW-SLVD1RF (clockwise from top; Top,
Side, and Front)
The -DIM1RF and -DIMS1RF contain one large
pushbutton, a light emitting diode (LED) with software
adjustable brightness*, and a three-position slider-switch,
shown after this paragraph. The -SLVD1RF is similar to
the -DIM1RF and -DIMS1RF but does not have the
slider-switch. Line voltage connections are made at the
rear of the dimmer.
1.75 in
(4.45 cm)
3.81 in
(9.68 cm)
4.13 in
(10.48 cm)
3.28 in
(8.32 cm)
1.88 in
(4.77 cm)
2.70 in
(6.86 cm)
1.50 in
(3.81 cm)
* LED brightness can only be adjusted through Crestron programming
software.
CLW-DIM1RF/-DIMS1RF (L) and CLW-SLVD1RF (R)
shown in white
The -DIM1RF, -DIMS1RF, and -SLVD1RF mount in a
standard wallbox and are covered using a decorative
faceplate (not included).
Physical view of CLW-DIM1RF/-DIMS1RF
(clockwise from top; Top, Side, and Front)
Industry Compliance
This unit has been manufactured to comply with UL’s
Standards for Safety in Canada and the United States.
Formal approval is pending.
1.75 in
(4.45 cm)
2.38 in
(6.03 cm)
3.28 in
(8.32 cm)
3.81 in
(9.68 cm)
4.13 in
(10.48 cm)
1.88 in
(4.77 cm)
2.70 in
(6.86 cm)
1.50 in
(3.81 cm)
Compliance Statement (Part 15.19 )
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation.
Warning (Part 15.21 )
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
RF Exposure (OET Bulletin 65 )
To comply with FCC's RF exposure limits for general
population / uncontrolled exposure, the antenna(s) used
for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and
must not be co-located or operating in conjunction with
any other antenna or transmitter.
Industry Canada Statement
The term "IC" before the certification/registration number
only signifies that the Industry Canada technical
specifications were met.
IC: 5683A-CWD1011
2 • Stand Alone Wall Box Dimmer : CLW-DIM1RF, DIMS1RF, & SLVD1RF Installation Guide – DOC. 6292