User Manual
Table Of Contents
- Isys i/O® 2.8” Handheld WiFi Touchpanel: TPMC-3X
- Introduction
- Setup
- Identity Code
- Battery Installation
- Power
- Battery Calibration
- Configuring the Touchpanel
- General Use and Safety
- Recommended Cleaning
- Programming Software
- Uploading and Upgrading
- Problem Solving
- Appendix: TBD
- Software License Agreement
- Return and Warranty Policies
Crestron TPMC-3X Isys i/O
®
2.8” Handheld WiFi Touchpanel
Configuring the Touchpanel
When power is applied to the unit for the first time, the following screen appears.
Initial Opening Screen
Touch the screen to display the following TPMC-3X setup screen.
Setup Screen
The setup screen enables basic configuration procedures prior to regular operation of
the touchpanel.
NOTE: During regular operation of the touchpanel, there are three ways to activate
the setup functions:
1. Place a button on the project main page and assign the reserved join number
(17242) that activates setup.
2. Press hard keys 1, 2, 3, and 4 in sequence twice (i.e. press 1, 2, 3, 4, 1, 2, 3, 4)
within a five second period. For hard key locations, refer to “Pushbutton
Programming” on page 34.
3. If the system bar is visible at the top of the display, you can also access the
setup screen by touching the Crestron swirl logo in the upper left corner.
Operations Guide – DOC. 6789C Isys i/O
®
2.8” Handheld WiFi Touchpanel: TPMC-3X • 15