Crestron SRD-AMP-1 High-Gain Line Amplifier Installation Guide
This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON All brand names, product names and trademarks are the property of their respective owners. ©2008 Crestron Electronics, Inc.
Crestron SRD-AMP-1 High Gain Line Amplifier Contents High Gain Line Amplifier: SRD-AMP-1 1 Introduction................................................................................................................................1 Block Diagrams ...........................................................................................................2 Specifications...............................................................................................................3 Included Items .........
Crestron SRD-AMP-1 High Gain Line Amplifier High Gain Line Amplifier: SRD-AMP-1 Introduction The SRD-AMP-1 is an inline amplifier intended for use in overcoming cable and splitter losses in a Crestron® XM or SIRIUS® satellite radio distribution network. It is rated to provide 16 dB (typical) of gain in the satellite radio band (2320-2345 MHz), and is powered from the DC bias voltage (4.5 VDC to 6.5 VDC nominal) provided by the antenna connection on the satellite radio tuner downstream.
High Gain Line Amplifier Crestron SRD-AMP-1 Block Diagrams The following diagrams illustrate three typical installation configurations using the SRD-AMP-1 line amplifier. Single SRD-AMP-1 Installation Double SRD-AMP-1 Installation Triple SRD-AMP-1 Installation 2 • High Gain Line Amplifier: SRD-AMP-1 Installation Guide – DOC.
Crestron SRD-AMP-1 High Gain Line Amplifier Specifications Following are specifications for the SRD-AMP-1. SRD-AMP-1 Specifications SPECIFICATION Gain Current consumption Power passing Environmental temperature Humidity Overall dimensions: Height Width Depth DETAILS 16 dB (Typical @ 4.5 VDC) 10 milliamps @ 4.5 VDC Both directions -40° to 150°F (-40° to 66°C) 0% to 98% RH (non-condensing) 0.64 in 3.25 in 1.07 in (1.63 cm) (8.26 cm) (2.
High Gain Line Amplifier Crestron SRD-AMP-1 Industry Compliance As of the date of manufacture, the SRD-AMP-1 has been tested and found to comply with specifications for CE marking and standards per EMC and Radiocommunications Compliance Labelling. Installation Refer to the illustrations on page 2, and, using the screws provided, orient and mount the amplifier(s) appropriately according to the distance between the antenna and the radio.
Crestron SRD-AMP-1 High Gain Line Amplifier Problem Solving Troubleshooting The table after this paragraph provides corrective action for possible trouble situations. If further assistance is required, please contact a Crestron customer service representative. SRD-AMP-1 Installation Troubleshooting TROUBLE POSSIBLE CAUSES CORRECTIVE ACTION No signal reception.
High Gain Line Amplifier Crestron SRD-AMP-1 SRD-AMP-1 Installation Troubleshooting (Continued) TROUBLE Limited reception or channels available for XM and/or SIRIUS tuners. POSSIBLE CAUSES Problem with tuner card. CORRECTIVE ACTION Ensure that the tuner card is registered/activated.
Crestron SRD-AMP-1 High Gain Line Amplifier Return and Warranty Policies Merchandise Returns / Repair Service 1. No merchandise may be returned for credit, exchange or service without prior authorization from CRESTRON. To obtain warranty service for CRESTRON products, contact an authorized CRESTRON dealer. Only authorized CRESTRON dealers may contact the factory and request an RMA (Return Merchandise Authorization) number.
Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON Fax: 201.767.7576 www.crestron.com Installation Guide – DOC. 6720A (2021527) 08.08 Specifications subject to change without notice.
