- Crestron Electronics Digital Audio Processor With Room Control Operations Guide C2N-DAP8RC

Digital Audio Processor with Room Control Crestron C2N-DAP8RC
32 • Digital Audio Processor with Room Control: C2N-DAP8RC Operations Guide - DOC. 8187A
Set up for communications as follows:
1. Initially, the Pass To check box is not selected indicating a direct
connection from your PC to the C2N-DAP8RC. Select Pass To if your PC
and the C2N-DAP8RC are connected through the control system via
Cresnet. Make certain the Cresnet ID setting is correct (50 is the default for
the C2N-DAP8RC). Refer to “Identity Code” on page 12 for more
information on setting the Cresnet ID.
2. Click on the Connection Settings Viewport Settings button to display the
“Port Settings” window. Select RS-232 as the connection type. Verify that
an available COM port is selected, and that all communication parameters
and necessary options from the “Port Settings” window are selected as
shown in the illustration on the next page. Click the OK button to save the
settings and close the window.
3. Synchronize communication between the PC and the device by clicking the
Transfer Configuration Load From Device button. This transfers any
current settings of the C2N-DAP8RC to the DAT program.
NOTE: Before making any adjustments via the DAT program, immediately save the
program (use File | Save As) to preserve the current device settings. This is
especially important if you are working on a device that has already been configured
and you subsequently need to restore those settings.