Owner's manual

AM/FM/XM Tuner Card Crestron Adagio
®
ATC-AMFMXM
Setup
This section contains hardware installation and setup instructions for the
ATC-AMFMXM.
Required Tools/Hardware
1. Small flat bladed screwdriver
2. Grounding strap (encouraged)
Installation
CAUTION: The ATC-AMFMXM and Adagio
®
systems contain electrostatic
discharge (ESD) sensitive devices. Crestron encourages you to wear a grounding
strap to avoid damaging the card and/or the host system.
When inserting a card into an Adagio system that features tuner card slots you may
need to move other source connections if designated connectors are occupied by
other sources. For programming purposes, slots and source connections are matched
according to the following table:
Slot 1 Slot 2 Slot 3
Source
Connections
1&2 3&4 Refer to
note below.
CAUTION: Do not connect external sources to SOURCES connectors used by
tuner cards.
CAUTION: Be certain to insert tuner card before applying power to the Adagio
system.
NOTE: If the user intends to use the out-of-the-box functionality, do not to use
SLOT 3 for tuner cards; otherwise, SLOT 3 uses source connections 5 and 6.
Begin the card insertion procedure with these steps:
1. Disconnect power from the Adagio system.
2. Remove the slotted screws securing any cover plate that may be
fastened to the slot you intend to use then set the screws and the cover
plate aside.
3. Unpack the ATC-AMFMXM card.
4. As shown in the photo on the next page, position the ATC-AMFMXM
card so the print on the faceplate is right side up and the side rails of the
card slide into the plastic slots mounted on left and right inside walls of
the Adagio system.
6 • AM/FM/XM Tuner Card: ATC-AMFMXM Operations & Installation Guide – DOC. 6462A