Installation guide

Crestron MPC-M50 Media Presentation Controller

Connectors, Controls & Indicators (Continued)

# CONNECTORS,

CONTROLS &

INDICATORS

DESCRIPTION

IR 1-2

(One group of two shown)

(4) Captive screw terminals comprising (2)

IR/Serial output ports;

IR output up to 1.2 MHz;

1-way serial TTL/RS-232 (0-5 V)

up to 115.2 k baud.

PIN DESCRIPTION

1 Signal

2 Ground

3 Signal

4 Ground

INPUTS 1–4

(5) Captive screw terminals comprising (4)

digital or analog input ports (referenced to

GND);

Digital input:

Rated for 0-24 VDC

Input impedance 20 kΩ

Logic threshold 1.25 VDC

Analog input:

Rated for 0-10 VDC

Protected to 24 VDC maximum

Input impedance 20 kΩ

Programmable 5 V, 2 kΩ pull-up resistor per

PIN DESCRIPTION

1 1

2 2

3 3

4 4

5 Ground

* To determine which is pin 1 on the cable, hold the cable so the end of the eight pin modular jack is

facing away from you, with the clip down and copper side up. Pin 1 is on the far left.

Operations & Installation Guide – DOC. 6814B Media Presentation Controller: MPC-M50 • 11