Installation Instructions

36
Install Lock Keeper – 2-Wide Door
NOTE: To obtain proper measurements and
accurately locate keeper, the active panel
must be installed in the door frame.
Follow previous installation and
adjustment procedures.
1. Measure distance from sill roller track to top
flat part of latch hook (FIGURE 1). Record this as
“A” (FIGURE 2).
2. Add 1/8" to “A” and mark this on the side frame
(FIGURE 2).
3. Position lock keeper so bottom of keeper hook
is in line with the mark on the side frame. Center
keeper in frame channel (FIGURE 3).
4. Attach with provided screws. Do not tighten
screws completely.
5. Close sliding door panel and activate lock to
check for lock-to-keeper alignment. Move keeper
up or down as necessary for proper locking.
Tighten screws.
6. The lock latch hook may be adjusted for better
locking. Turn latch hook adjustment screw clock-
wise to extend the latch hook and counterclock-
wise to retract it (FIGURE 4).
Track
(Side View)
Measure
From Here
Roller
1
FIGURE 1
Frame
Track
Rolle
r
(Face View)
Measure
1/8"
"A"
Panel
Hook
Latch
To Here
Mark Here
2
1
FIGURE 2
3
Rolle
r
Track
"A" + 1/8"
Keeper
FIGURE 3
FIGURE 4
LATCH
ADJUSTMENT
SCREW
TURNING
SCREW
MOVES
LATCH IN
OR OUT