Installation Instructions

34
9. Turn panel (FIGURE 13) so installation screws
on second roller assembly are accessible. Repeat
steps 4 through 8 for this roller assembly.
Before next step check that:
• Installation screws are firmly secured
• Screw hole covers are applied
10. Stand panel upright so rollers (that were moved
to the top) now rest on the floor (FIGURE 14).
11. Install sliding panel into frame following Panel
Install procedures on Page 18.
NOTE: The sliding panel lock mechanism must be
reversed so the latch hook is upward. See
procedure starting on the next page.
PANEL ROTATED
TO ACCESS 2ND
ROLLER ASSEMBLY
TURN PANEL TO
ACCESS SCREWS
FOR SECOND
ROLLER ASSEMBLY
MOVE 2ND ROLLER
ASSEMBLY FROM
BOTTOM TO TOP
Original Bottom
Original Bottom
Original Top
Original Top
SLIDING
PANEL
(reversed)
[viewed from
the outside]
Original Bottom
Original Top
FIGURE 9
Reversing Sliding Panel (cont.)
FIGURE 10