Installation Instructions

32
Reversing Sliding Panel
The reversing process starts on page 30. If you
have not completed all the steps on pages 30 and
31 go back and perform those procedures before
proceeding.
Move rollers from bottom to top of panel.
1. If active panel is not removed from frame
(FIGURE 1), remove it according to procedures on
page 18
2. Lay panel on its long side so interlock is up
(FIGURES 1 & 2). Secure panel in this position so
it will not move or fall while roller assemblies are
moved.
3. Peel off vinyl cover to expose roller mounting
screw (FIGURE 3).
4. Turn installation screw (FIGURE 4) counter-
clockwise until roller assembly is disconnected
from screw. Remove screw from frame and keep
for later use.
NOTE: Bottom screw in FIGURE 4 is the panel
adjusting screw. Do NOT remove.
FIGURE 1
FIGURE 2
SLIDING
PANEL
(removed
from frame)
SLIDING PANEL
ROTATED TO REMOVE
ROLLER ASSEMBLY
Original Top
Original Bottom
MOVE ROLLER ASSEMBLY
FROM BOTTOM TO TOP
Original Bottom
Original Top
FIGURE 3
FIGURE 4