Installation Instructions

28
Attach Handles to Door
Handle with lock will attach to door with latches
(FIGURE 7). Door with keeper (FIGURE 8) gets
the handle set without the lock hole.
7. From the exterior, align posts on bottom of
exterior handle with holes in door stile (FIGURE 9).
Feed the lock post through the center hole.
8. Arrange escutcheon plate on the interior with
latch lever notch facing the stationary panel (FIG-
URE 10).
9. From the interior, Install one Phillips, flat head,
long machine screw through one escutcheon plate
hole, through the door stile, and into the screw
post on the exterior handle (FIGURE 10). Tighten
the screw but leave it slightly loose.
10. Install the second Phillips, flat head long
machine screw as above.
IMPORTANT: Ensure screws are not
cross threaded. Do not over tighten screws.
When both screws are properly threaded, tighten
securely to hold exterior handle and escutcheon
plate to the door stile. Repeat above steps for
other door panel.
FIGURE 7
FIGURE 8
FIGURE 9
ESCUTCHEON
PLATE
ASTRAGAL
INTERIOR
MACHINE
SCREWS
LATCH
LEVER
NOTCH
FIGURE 10
Handle Installation – 4-Wide Door (cont.)