Installation Instructions

Handle Installation – 2-Wide Door

Door stiles are pre-drilled for handle sets (FIGURE

4). The lock mechanism is installed in the sliding

panel. The keeper is to be installed in the fixed

panel.

1. Locate the two handles, two escutcheon plates,

and four 3/8" long round head Phillips machine

screws in the hardware package. One set is shown

in (FIGURE 1).

2. Align handle with circular insets in escutcheon

plate and then screw handle securely to plate from

the back side with two screws (FIGURE 2). Repeat

for other handle.

3. The handle with the key lock attaches to the

door’s exterior (FIGURE 3). The handle with the

locking lever attaches to the interior of the sliding

panel (FIGURE 4).

4. Align the exterior handle with the pre-drilled

holes in the door and insert the tube nuts through

the holes in the escutcheon plate and into the door

stile holes (FIGURE 3). Hold handle in place by

hand. Note the handle direction.

5. While holding the exterior handle in place, align

the interior handle and insert the latch tail into the

lock of the exterior handle (FIGURE 4).

Continued on next page.

FIGURE 1

FIGURE 2

FIGURE 3

TUBE

NUTS

EXTERIOR

FIGURE 4