Installation Instructions

22
Once the sliding panels are installed and fully
supported on their roller systems, additional
adjustments may be required to:
• Align panels that contain grille or SDL options.
• Adjust astragal connection on 4-Wide active and
inactive panels.
• Fine tune handle set engagement.
When there are decorative options such as grilles
in airspace, simulated divided lite bars, etc., the
roller adjustment system can be used to align the
panels and the decorative features (FIGURE 1).
IMPORTANT: Carefully follow the pre-
ceding panel adjustment steps until alignment
is achieved.
If necessary, the astragal and shoot bolt alignment
on 4-Wide door units can also be slightly adjusted
using the panel rollers.
NOTE: There is greater adjustability built into the
shoot bolt system than is available through
panel roller adjustment
Install Sliding Panels – 4-Wide Door (cont.)
Panel Adjustments – All Installations
Shoot Bolt Adjustment 4-Wide Door
10. Install the second sliding panel in the 4-Wide
door frame following the same steps described
above for the first panel.
After both panels are installed follow appropriate
adjustment procedures as described below.
USE ROLLER
ADJUSTMENT
TO HELP ALIGN
GRILLE BARS
FIXED
PANEL
SLIDING
PANEL
There is a head and sill shoot bolt keeper for the
inactive panel. They are screwed in place at the
factory. Each keeper has two adjustment slots
(FIGURES 2 & 3).
1. To realign the keeper and shoot bolt, loosen the
screws and slide keeper left or right to obtain
improved alignment.
2. Tighten screws to hold keeper in new position.
FIGURE 1
FIGURE 2
SILL
SHOOT
BOLT
KEEPER
ADJUSTMENT
SLOT
SILL
SHOOT
BOLT
KEEPER
Cover
Removed
from Panel
EXTERIOR
FIGURE 3
SHOOT
BOLT
KEEPER
ADJUSTMENT
SLOT
HEAD
SHOOT
BOLT
KEEPER
EXTERIOR