Installation Instructions

21
Install Sliding Panels – 4-Wide Door (cont.)
FIGURE 7
FIGURE 8
Track
Roller
Sill
Panel
Sliding
Fixed
Panel
Hole Plugs
Head
Adjustment
Screw
Roller Installation
Screw
6. With panel upright and rollers down, position
panel close to its proper (active or inactive) side
frame.
7. Angle panel as in (FIGURE 7) and lift it up into
the head frame channel.
8. While holding panel up into head frame channel,
carefully push bottom of panel away from you until
it clears the inside of the sill and is positioned
properly in the frame channel. A stiff-bladed putty
knife can be used to help slide panel into channel
(FIGURE 8).
NOTE: The rollers must be correctly seated on the
sill track so the panel operates smoothly.
Groove of rollers must rest on crown of sill
track cap (FIGURE 9).
Before operating panel, adjust
sliding panel rollers so they
support the panel. Damage to panel or sill track
cap may occur if rollers are not supporting
panel before it is slid open or shut.
NOTE: Top screw seen in (FIGURE 10) is the
roller installation screw. Do NOT use the
top screw for adjusting rollers.
Roller Adjustment – Turn adjusting screw
(FIGURE 10):
Clockwise – Lower Rollers – Raise Panel
Counterclockwise – Raise Rollers – Lower Panel
NOTE: Before adjusting rollers, use putty knife to
lift panel slightly, taking weight off rollers
(FIGURE 8).
9. Use roller adjustment screw (FIGURE 10) to
raise or lower panel to achieve smooth operation
and to keep panel level and plumb.
Continued on next page.
SILL
TRACK
CAP
SILL
TRACK
ROLLER
INTERIOR
DOOR
FRAME
SLIDING
PANEL
FIGURE 9
FIGURE 10
Relieve pressure on roller
assembly by lifting panel with a
stiff-bladed putty knife (FIGURE 8) while turn-
ing roller adjusting screws. Failure to release
panel weight while turning adjustment screws
may damage panel adjustment system.
Roller
Assembly
Sliding Panel
Roller Installation
Screw
Roller
Adjustment Screw