Installation Instructions

16
Removing Screen, Installing Screen Guides
Installing Screen
A 2-Wide door screen is normally shipped installed
in the door frame. It must be removed to install the
screen guides.
4-Wide door screens are packaged separately with
the active panels.
Removing Screen – 2-Wide and 4-Wide Door
1. Retract top and bottom screen rollers by turning
the screen roller adjustment screws counterclock-
wise with a Phillips screwdriver (FIGURE 1 & 1A).
2. On 2-wide door open screen enough to grasp
the sides.
2. On 4-wide door, after retracting rollers, slide
screens open to disengage the astragal.
3. Lift screen gently until top is fully up into the
head frame screen channel (FIGURE 2).
4. While holding screen up into head frame
channel, carefully pull screen outward until screen
bottom clears bottom channel and top can be slid
out of upper channel.
Installing Screen Guides
Screen guides are included in the screen keeper
package. These are used to stabilize the top of the
screen in the screen channel, preventing excessive
movement and unwanted noise. If screen is
already installed, remove screen (see Removing
Screen).
1. Position guide above top screen channel, about
3" from the end of the screen (FIGURE 3).
2. Press down firmly to snap screen guide into
channel.
3. Repeat procedure for other side. Install two
screen guides on the top of each screen.
Installing Screen – 2-Wide and 4-Wide Door
NOTE: If you have a 4-Wide unit, do not reinstall
the screens at this time. Set safely aside
for later installation
1. If not already done, retract top and bottom
screen rollers by turning the screen roller adjust-
ment screws counterclockwise with a Phillips
screwdriver (FIGURE 1 & 1A). If rollers are
retracted, proceed to Step 2 below.
2. Grasp sides of screen and lift top into head
frame screen channel (FIGURE 2).
3. Carefully push screen inward until it is in place
in the frame channel and the rollers are properly
positioned on the screen track.
4. Perform screen adjustment procedures on next
page to ensure smooth operation.
Screen
Top of Screen
3"
Screen Guide
Guide
Roller
Screen
Channel
FIGURE 3
FIGURE 1
FIGURE 2
Sill
Track
Screen
Screen
Inactive
Panel
Panel
Sliding
Head
2
Screen
Roller Adjustment
Screw
1
1A