Installation Instructions

ManualsBrandsCrestline ManualsDoorsSelect 250 Series 72" W x 80" H White Vinyl Sliding Patio Door with Safeguard™ Certified Glass

Weather Barrier Tape Application – Non-DP Installations

The joint between the nailing fin and wall surface

must be sealed with strips of weather barrier self-

adhering tape.

Preparation

1. For the sides, cut two pieces of weather barrier

self-adhering tape that are 9" wide and 18" taller

than the door (FIGURE 1).

Cut the head piece 9" tall and long enough to span

the door & side tapes; plus 2" (FIGURE 1).

Do not apply tape yet. Complete caulking

instructions that follow.

2. Apply a generous, continuous bead of silicone

sealant on the nailing fin over the fasteners.

NOTE: Caulk is not required if self-adhering tape is

used.

Start 9" above the door and run the bead to bottom

of nailing fin (FIGURE 2). Repeat for the other side

frame. Also apply sealant along the head nailing fin

(FIGURE 2).

Tape Application

First – Apply Side Pieces

Start at the top, about 9" above the door (FIGURES

3, 3A & 3B). Apply tape to the face of the wall close

to the door frame and work toward the bottom.

Tape must

cover the entire nailing fin, including the

installation holes, the joint between the fin and the

building’s sheathing and

extend out onto the exteri-

or wall. Use a rubber roller to get good contact with

the wall surface.

FIGURE 1

APPLY SILICONE SEALANT

TO NAILING FIN AT HEAD

AND SIDES, BEFORE

APPL

YING

ATHER BARRIER TAPE.

(Sealant not required when

self-adhesive tape is used

over the nailing fin.)

FIGURE 2

APPLY SIDE

PIECES

FIRST

9" Typ.

Typ.

HEAD PC. LGTH. =

WIDTH + 2"

WIDTH

FRAME HEIGHT+

9" + 9" = SIDE

PIECE LENGTH

FIGURE 3