Operation Manual

12
English
6 Troubleshooting
Causes
Units cannot be
turned on.
− Check that you have turned the power on from the mains and that the
connections are firm.
The green Link"
light on the Parent
Unit is flashing
and you cannot
hear the sounds
from your baby‘s
room.
− 1. You may have moved out of range −move closer to the Baby Unit and
wait 5 seconds for the Link" to establish.
− 2. You may need to re−establish the Link" between the two units. Turn both
units off and then:
On the Baby Unit:
−Press and release the On/Off key.
On the Parent Unit:
−Press and release the On/Off key. The green Link" light comes on (this
may take a few seconds).
Can’t hear your
baby on the
Parent Unit, but
the Link" light is
still glowing
steadily.
− 1. Check the volume is turned up on the Parent Unit.
− 2. You may need to turn up the sensitivity of your Baby Monitor.
Your Baby Monitor
is emitting an high
pitched
ear−piercing noise.
− This may happen if your Parent and Baby Units are too close together.
Move them further apart.
Faults