Owner`s manual

Front panel features

FROMMONITOR

The post-level control MONITORoutput becomes the signal in the head-

phones when nothing is soloed. This overrides TAPEINif the TAPEINbutton is

depressed.

TAPEIN

The TAPEINsignals appear in the headphones when the FROMMONITOR

button is not depressed and nothing is Soloed.

ADD MONO to Phones and ALTOUT

Mono, or Center can be added when the LEFT and RIGHT masters are present

at the Phone out, on the front panel and the ALTOUTjacks on the rear panel.

The switch is recessed to prevent it’s state from acidentaly being switched.

The default signal at the Headphone output and the ALTOUTjacks is the

stereo LEFT/RIGHT mix.

In addition to the LEFT/RIGHTmix at he the Headphone output and the

ALTOUTjacks, the MONOmaster signal is blended in.

12 V Lamp jack

A BNCjack is used for hooking up a goose-neck lamp. The center connection is

12 Volts DCand the outer connection is ground. A medium or high-intensity 12V

DC Littlite is can be used.

LEDmeters - Left and Right

A pair of LED arrays are provided for monitoring the output levels. They fol-

low the SOLO system, making it easy to adjust input and output levels by PFL’ing

and AFL’ing different sources. They normally show the LEFTand RIGHToutput

levels. When something is Soloed, it replaces LEFTandRIGHTon the meters.

SOLO LED

This red LED lights up when anything on the mixer is soloed.

PWRLED

This green LEDilluminates to indicate that the mixer is powered up and

ready for use.

Master section

p.29