Owner`s manual

AUX send features

Six auxiliary sends are available for creating individual output mixes. These can be

used to drive effects processors, provide monitor mixes, create broadcast or

alternate sound reinforcement mixes, or for other special requirements.

Note: The default PRE setting for the Auxes is pre-fader, but post-mute,

post-insert, and post eq. Internal settings changed be changed so that PREis also

pre-eq and pre mute

Aux 1 - 2 PRE

AUX 1/2 stereo pair is post fader

AUX1/2 stereo pair is pre-fader

Aux sends 1 & 2

Auxes 1 and 2 are configured as a stereo pair. If the channel is configured as a

stereo input, the Left and Right signals are routed to Auxes 1 and 2, retaining the

stereo split. The PANknob acts as a balance control. This stereo aux send can be

used for any type of stereo feed from the console, such as live two-track record-

ing, stereo in-ear monitors, alternate stereo feed for broadcast, and stereo signal

processors. Also, by using the pan control to select a single bus, Auxes 1 and 2

can be used as discrete mono Aux buses

Aux 1/2 level Sets level for the Aux 1/2 stereo pair

Aux 1/2 PAN If the MONOSUM button is up, this knob controls the

stereo balance for Auxes 1 and 2. If the MONO SUM button is down, the

summed signal is panned between Auxes 1 and 2

AUX 3-4 PRE

AUX 3 and AUX 4 are post fader

AUX3 and AUX 4 are pre-fader

Aux sends 3, 4, 5 & 6

Auxes 3, 4, 5, & 6 are configured as descrete mono aux sends. They are typically

used to feed signal processors and for on-stage monitors. Stereo signals are

summed together to make up the source for Auxes 3, 4, 5 & 6.

Auxes 3, 4, 5, & 6 level Set levels Auxes 3, 4, 5, & 6.

AUX 5-6 PRE

AUX 5 and AUX 6 are post fader.

AUX5 and AUX 6 are pre-fader.

p.21

Stereo Input channel