Owner`s manual

AUX send features

Six auxiliary sends are available for creating individual output mixes. These can be

used to drive effects processors, provide monitor mixes, create broadcast or

alternate sound reinforcement mixes, or for other special requirements.

Note: The default PRE setting for the Auxes is pre-fader, but post-mute,

post-insert, and post eq. Internal settings can be changed so that PREis also pre-

eq and pre mute

Aux 1 - 2 PRE

AUX 1/2 stereo pair is post fader

AUX1/2 stereo pair is pre-fader

Aux sends 1 & 2

Auxes 1 and 2 are configured as a stereo pair. The top knob controls the level

and the bottom knob acts as a PANcontrol. This stereo aux send can be used for

any type of stereo feed from the console, such as live two-track recording, stereo

in-ear monitors, alternate stereo feed for broadcast, and stereo signal processors.

Also, by properly using the pan control Auxes 1 and 2 can be used as discrete

mono Aux buses

Aux 1/2 level Send level for the Aux 1/2 stereo pair

Aux 1/2 PAN Stereo placement for the Aux 1/2 stereo pair

AUX 3-4 PRE

AUX 3 and AUX 4 are post fader

AUX3 and AUX 4 are pre-fader

Aux sends 3, 4, 5 & 6

Auxes 3, 4, 5, & 6 are configured as descrete mono aux sends. They are typically

used to feed signal processors and for on-stage monitors.

Auxes 3, 4, 5, &6 level Set levels Auxes 3, 4, 5, & 6.

AUX 5-6 PRE

AUX 5 and AUX 6 are post fader.

AUX5 and AUX 6 are pre-fader.

p.11

Mono Input channel