Owner`s manual

Table Of Contents
DEUTSCH p.19
ENGLISH p.1
FRANÇAIS p.39
ESPAÑOL p.58
1.0 Introduction
2.0 Getting Started
2.1 Unpacking
2.2 Installation and Mounting
2.3 Requirements and Considerations
3.0 Amplifier Layout
3.1 Front Panel
3.2 Rear Panel
3.3 Side Panels
4.0 Amplifier Operation
4.1 Input Sources
4.2 Output Connections
4.3 Output Configuration
4.4 Removable Attenuator Knobs
4.5 Gain Select Switch
4.6 Signal Ground Lift Switch
4.7 Sequential Turn-On/Turn-Off (STO)
4.8 Module Bay
4.9 TourClass
®
Protection Features
5.0 NexSys Module Basics and Installation
5.1 Installation
5.2 Software Control Concerns
6.0 NexSys Module Layout
6.1 NxEthernet Module
6.2 NxCobraNet Module
6.3 NxDSP Module
7.0 Network Module Operation
7.1 Making Network Connections
7.2 Setting the I.P. Address
7.3 Setting the Amp I.D.
7.4 Adjusting the Gain
7.5 Condition Monitoring
7.6 Fault Monitoring
7.7 NxCobraNet Specific Features
7.8 Advanced Features Menu
8.0 NxDSP Operation
8.1 Blah blah blah
8.2 Blah blah blah
9.0 Service Information
Appendix A: Electrical Specifications
& Block Diagrams
i. CKi
ii. CKi-V
iii. CKi-X
Appendix B: Network Setup Examples
Appendix C: Distributed (Constant Voltage) Systems Information
Appendix D: Wire Gauge Charts
Ci
TM
Owner’s Manual