Owner`s manual

NexSys

Modules

NexSys module installation diagram

NexSys Modules 7

Module Features

These following pages describe the buttons, indicators, connectors and functional

components that are relevant to the two NexSys modules. These features exist

on both the NxEthernet8 and NxCobranet8 Modules. Features specific to the

NxCobranet8 Module are discussed later in this chapter.

4-character Display

The LED display shows the value of the current parameter for the function chosen.

The selected Function is indicated by the corresponding LED.

Edit Button

Enables and disables editing of a function parameter. When pressed, the value in the

display will flash, indicating that edit mode has been entered.The value can now be

adjusted using the increment and decrement buttons. Pressing Edit again will register

the value and stop the flashing of the display.

Select Button

When a function parameter exists for both channels independently (e.g.

Gain,Temperature), this button changes between the parameter values for Channel

A and Channel B. This button is also used to select parameters within a given

function.

Function Button

This button scrolls through the functions that can be controlled from the module

panel including: I.P.Address,Amp ID, Gain,Temperature, AC Line Voltage. As each is

selected, the corresponding LED wil light and the appropriate function parameter

will appear in the display.

Increment/Decrement Buttons

When the module is in edit mode and the value in the display is flashing, the

increment and decrement buttons will adjust the value.

Function LEDs

Each of the main functions has a corresponding LED. When a function is selected,

this LED will light to identify the selection. Some secondary functions do not have

an associated LED, so no LED will light when these functions are selected.

Note: Not all function parameters can be adjusted

(e.g.AC Line Voltage,Temperature, etc.) as they are output values only.