Owner`s manual

Features Overview
rear panel
1
Circuit Breaker
A push type circuit breaker is located on the rear of the amplifier. If this breaker trips repeatedly,
the amplifier needs servicing.
2
IEC Connector
A standard IEC power connector is located on the rear panel of amplifier. The connector
accommodates a standard IEC line cord, included in the amplifier box. Should this cord need to
be replaced, only a cord with the same current rating should be used.
3
STO Connectors
These connectors can be wired to a contact closure for remote turn-on and to other Ci/Cki/CK
amplifiers for sequential turn-on (STO).
4
Power LED
The Power LED indicates the amplifier has AC power. Same as front panel LED.
5
Active LED
The Active LED indicates the amplifier is “Active” (turned on). Same as front panel LED.
6
Output Connectors
A barrier strip provides output connection terminals for two speakers operating in stereo or for
a single speaker wired in a bridged mono configuration. Bare wire or spade lugs may be used to
make barrier strip connections.
7
Bridged Mode Switch
This switch reconfigures the amplifiers outputs for stereo or bridged operation.
Ci
TM
Owner’s Manual
1 2 3 4 5 6
6 6 6 6
6 6
6 6 6 6
6 6
7 8 9
0 Ô £¡