Specifications

44. AUX 3/5, AUX 4/6

AUX 3/5 adjusts the level of the channel’s LEFT post-fader signal that is added to either AUX

3 or AUX 5 mix according to the AUX 3/4 – AUX 5/6 switch position. AUX 4/6 adjusts the level

of the channel’s RIGHT post-fader signal that is added to either AUX 4 or AUX 6 mix

according to the AUX 3/4 – AUX 5/6 switch position. Unity gain is at the center detent

position and +10 dB of gain is at the full clockwise position.

45. PFL

The PFL switch connects the channel’s L and R pre-fader signals to the PFL single mix. At

the same time it switches the headphone and control-room outputs from the Master L/R

(main) mix (default) to the PFL. It also connects the PFL signal to the R meter to aid the

setting of the input gain and is not affected by the mute switch position. The (right) PFL meter

will read 0 dB when there are signals present at both L and R channels simultaneously. If

there is only one signal present at either one of the L or R channels the meter will read –6 dB

lower.

VII. MASTER SECTION

46. MASTER GROUP 1—4 FADERS

This smooth 60 mm, logarithmic Group 1—4 mix output

level control sets the levels of the Group1-4 channels sent to the

output connectors (ranges from -97 to +10 dB). The

reference setting for these controls is “0 dB” — unity gain

position.

47. MASTER GROUP 1—4 “R” ASSIGNMENT SWITCH

Each “R” ASSIGNMENT SWITCH assigns the Group post-

fader signal to the Master R channel.

48. MASTER GROUP 1—4 “L” ASSIGNMENT SWITCH

Each “L” ASSIGNMENT SWITCH assigns the Group post-

fader signal to the Master L channel.

49. PFL

The PFL switch connects the Group 1-4 pre-fader signal to

the PFL mix. At the same time it switches the headphone

and control-room outputs from the Master L/R mix (default)

to the PFL. It also connects the PFL signal to the R meter. Depressing any one of the PFL switches

illuminates the corresponding group yellow-LED and simultaneously activates a blinking (1 Hz)

yellow master LED in the master-PFL section.

50. MASTER L/R FADERS

These smooth 60 mm, logarithmic Master L/R mix output level controls

set the levels of the Master L/R channels sent to the output connectors

(ranges from -97 to +10 dB). The reference setting for these controls is

“0 dB” — unity gain position.

51. LED METER

This two-channel, 12-segment LED peak level meter with -33 to +9 dB

range and CLIP indicator (-2 dB below clipping), displays the Master L/R

signal (default). The 0 dB reading corresponds to +4 dBu at the balanced

outputs or 0 dBu at the unbalanced outputs. The R meter is also used with

priority for PFL metering.