User`s manual

ManualsBrandsCressi ManualsComputer equipmentEDY

206

5 DIVE program; picture 8a GAGE program; picture 8b FAEE pro-

gram) and following the already described procedures. At

this point, depress button C ( ) once to switch on

the possibility of selection. Use again button C ( )

to select the maximum depth alarm and set the wished value

(between 0 and 324,7 ft.), by depressing button D ( ).

When the wished depth has been set, use again buttons C

( ) and D ( ), to switch on or off the alarm.

Depress button A ( ) for some seconds to revert back

to the normal display (picture 1).

Related topics:

• 2.4.1. - DIVE program parameters setting

• 2.5. - GAGE (or depth gauge/timer) program parameters

setting

• 2.6. - FAEE (or apnoea) program parameters setting

2.7.2. - Date and time adjustment (

SET

).

To adjust dare and time, depress button A ( ) in

sequence until the (SET) icon is displayed; then, depress button

C ( ) to select the function you wish to vary, accor-

ding to following sequence (picture 10):

1) Seconds; 2) Minutes; 3) Hours; 4) 12/24h;

5) Year; 6) Month; 7) Day.

The values are varied by pressing button D ( ).

Depress button A ( ) for some seconds to revert back

to the normal (picture 1).

NOTE: always check tome and date in order to get cor-

rect entries in you computer’s logbook.

Related topics:

• 2.2. - Clock function

• 4.2. - Dive logbook (LOG)

2.7.3. - Units of measure setting.

Cressi-sub computer can make computations both by

metric units (depth in meters and temperature in °C) and by

feet units (depth in feet and temperature in °F).

To change the units of measure, depress button A ( )

in order to get to the first menu of (DIVE) program (picture 5).

Then, depress button C ( ), making the (DIVE) flash.

At this point, depress buttons C+D in sequence and keep

them both depressed for about 6 seconds. While doing so,

PO2 value will be flashing, a sound alarm will start and the

new unit of measure will be displayed.

Depress button A ( ) for some seconds to revert back

to the normal display (picture 1).

EDY.qxd:EDY Manuale2006-2.qxd 20-06-2008 11:51 Pagina 206