Specifications

Environmental and Electrical Requirements

See chart on page 6 for electrical requirements that are matched to your Xerox Creo Print Server.

Product Recycling and Disposal

Xerox operates a worldwide equipment take back and reuse/recycle program. Contact your Xerox

sales representative (1-800-ASK-XEROX) to determine whether this Xerox product is part of the

program. For more information about Xerox environmental programs, visit

www.xerox.com/environment.

Note: This product meets the RoHS standards (Restriction of Hazardous Substances) required for

products being installed in the European Union.

Space Requirements

See chart on page 6 for space requirements that are matched to your Xerox CX Print Server. Refer

to the base system Customer Expectations Setting guidelines for calculation instructions to

determine the space that is required around the system in its various configurations.

To enable a Xerox Service R epresentative to safely repair the system, the work area must measure

at least 36 inches (91.44 cm) square around the server.

The work surface of the network controller must not infringe on the space requirements by the print

engine and any attached accessories unless the work surface is a table that has wheels and can

easily be moved. Refer to the appropriate print engines Customer Expectation Document.

There must be a minimum of 78 inches (198.12 cm) clearance from the floor to the nearest

overhead obstructions.

All standard Xerox space requirements apply to this installation including overhead, shared, aisle or

hallway, and operator space. The customer is responsible to provide appropriate floor spacing and

placement surface.

Storage and future availability of software that ships with the color server is a customer

responsibility. Xerox personnel do not carry replacement materials.

Note: Power cords for the Print Servers are approximately 7.5 feet (2.3 meters). The outbound video

cables to the new iGen Press is approximately 16.4 feet (5 meters). Always check with the

appropriate engine guidelines for exact measurements.