EN Automatic Coffee experience engineered in Switzerland
Safety notes 3 For your safety − First read this entire operating manual, and keep it in a safe place for other users − To avoid damage, only use genuine cremesso capsules with this machine − Intended use:This appliance may only be used as described in this manual. Using it for other purposes is abusive and dangerous − Danger of electric shock! Never immerse the machine in water or any other liquid − Connect only to a properly grounded power point (220-240 V) protected by at least a 10 A fuse.
4 Welcome in the world of cremesso 5 Contents Congratulations on choosing the cremesso system! It will give you the greatest pleasure – capsule by capsule. In a few seconds your cremesso UNA will conjure up all kinds of perfectly prepared beverages: the first-class cremesso coffee and tea selection meets even your most discriminating demands. We thank you for your confidence in cremesso, and wish you many years of enjoyment. At www.cremesso.
6 Overview of machine parts and controls 7 Key displays Operating keys ➔ Facing page Operating lever for loading capsules Capsule container retractable Output (hot!) for coffee, tea and hot water Insert drain grille/ tray for large cups in bottom openings ➔ Page 8 Openings Insert drip tray for small cups in upper opening ➔ Page 8 The keys light up differently according to operating mode: White (slow flickering): – Energy-saving mode, press key ➔ Page 12 White (continuous): – Ready or Coffee/tea out
8 Starting up 9 Preparation / installation / water filling / power connection / deaerating 1. 2. Cup size: Insert drip tray in top or bottom opening, depending on cup size: Clic 1. Insert tray obliquely into top or bottom opening, 2. Press down (clicks in place). Remove tray in opposite order Carry/Transport: Never hold the machine on the drip tray (risk of dropping machine)! Install on a dry, stable, waterproof and heatproof surface.
10 Making coffee or tea / after making coffee or tea 11 Your first coffee or tea! 1. 2. Use one cremesso capsule for each cup. No other types of capsule can be used. After long pauses, deaerate the piping ➔ page 16. Cup: place a cup under the output. Insert drip tray into top or bottom opening ➔ S. 8 3. Load capsule: 1. Push the operating lever right back. 2. Drop the capsule straight into the opening. 3. Pull the operating lever right forward to pierce the capsule 1.
12 Special functions 13 Programming the coffee quantity 1. 3. 3 sec. 2. Programming: Place a cup under the output Load capsule: 1. Push the operating lever right back. 2. Drop capsule straight into the opening. 3. Pull operating lever right forward Hold down the key to be pro(min. 3 seconds) grammed, e.g. until it starts flashing rapidly. It then flickers slowly (= heating up) Coffee output starts.
14 Cleaning / Maintenance / Descaling 15 Daily: Empty the capsule container, drip tray and water tank max. 55 °C 0.65 l Hold the drip tray firmly and pull it forward Remove the capsule container, drip grille and drip tray. After cleaning reassemble in the opposite order Good to know Hygiene: Empty the water tank daily. Empty the used capsule container, drainage tank and drip tray after about 10 beverages or at least once daily to prevent overflow.
16 Cleaning / Maintenance / Descaling 17 Rinse and deaerate the machine and piping 0.65 l Before first startup or after long pauses (e.g. vacations), flush and vent the machine Fill water tank with cold water (max. 0.65 l) Place a cup under the output. Do not insert a capsule. If key flickers slowly, press any key to start rinsing/ Press key deaerating.
18 Cleaning / Maintenance / Descaling 19 At least every 2 months: descale Important! Regular descaling (at least every two months) means better coffee and makes your appliance last longer. Scaling is not covered by the guarantee. Use special descaler (never use vinegar) following the mixing instructions on the label. Remove all capsules from the machine before descaling. Descaling takes about 30 minutes.
20 Cleaning / Maintenance / Descaling 21 Always steam out prior to storage or transport +5 °C To avoid damage during storage or transport, first steam out the machine (to remove all water). This is essential at temperatures below 5 °C + Pull out the power plug. Empty the water tank and replace it. Place a cup under the outlet Hold down the Lungo/Tea key and insert the power plug.
22 Various 23 Troubleshooting guide Disposal Repairs to your machine may only be carried out at the Service centre. Unprofessional repairs and use of non-original replacement parts can be dangerous for the user. In case of unprofessional repairs, no liability will be accepted for resultant damage and the guarantee is invalidated. If this troubleshooting guide does not help you solve your problem, please contact your local sales point.
www.cremesso.
