Instructions / Assembly

LPN000212_A

www.creebulb.com

REMOVAL OF FIXTURE

NOTE: Make sure power to fixture is

disconnected before attempting to

remove fixture module from fixture.

STEP 1:

To remove fixture, grip firmly on

the trim ring and rotate 1/4 turn

counterclockwise to unlock clips

from recessed can.

STEP 2:

Continue to turn counterclockwise

while pulling downward on the

fixture. This will disengage the clips

allowing the fixture to pull free.

STEP 3:

Detach fixture from recessed housing

socket.

NOTE: This device is not intended

for use with emergency exit

fixtures or emergency exit lights.

2 of 2

6 7

STEP 6:

If the trim ring is not flush with the ceiling,

remove fixture by turning counterclockwise

while pulling downward. Remove the fixture

completely from the recessed can by turning

the fixture Edison base counterclockwise.

STEP 7:

Locate the recessed can socket and remove

socket bracketry and/or socket plate to allow

the socket to hang freely. See Figures 5, 6

and 7.

STEP 8:

Screw in fixture Edison base back to the

recessed can socket and reinstall fixture into

the recessed can.

See www.creebulb.com/warranty for warranty and specifications. Cree® is a registered trademark, and the Cree logo is a

trademark of Cree, Inc.

In accordance with California Proposition 65, Cree provides the following statement due to the customary electronics

components used in this product. WARNING: This product contains a chemical known to the state of California to

cause cancer. WARNING: This product contains a chemical known to the state of California to cause birth defects

or other reproductive harm.