User's Manual

ManualsBrandsCree ManualsElectronics2.4 GHz Transceiver

LPN00212X0006A1_B

1 of 2

INSTALLATION INSTRUCTIONS

Cree Configuration Tool With SmartCast™ Technology

Wireless Configuration Tool

Includes: CCT-CWC-1

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed

including the following:

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

1. Caution: The batteries used in this device may present a re or chemical burn hazard if

mistreated. Do not recharge, disassemble, heat above 100°C (212°F) or dispose of in re.

Replace batteries with CR123A type only. Use of another battery may present a risk of re

or explosion.

2. Dispose of used batteries properly. Keep away from children. Do not disassemble and do

not dispose of in re.

3. Replace batteries at the same time using fresh cells only.

4. Avoid direct eye exposure to forward facing LED.

5. Indoor use only and suitable for damp locations.

6. Any changes or modications to these devices not explicitly approved by manufacturer

could void your authority to operate this equipment.

SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE

• USB cable ( part number: LAH00206X0001A0 ) can be used to power the device in the

absence of working batteries.

UNIT DESCRIPTION- FIGURE 1

The Cree Conﬁguration Tool is used to set up and

conﬁgure Cree SmartCast™ Technology enabled devices.

Revolutionary OneButton™ Setup enables automated

setup of luminaires and dimmers with little to no installer

intervention. With the press of a single button, SmartCast™

Technology enabled luminaires and dimmers create their

own secure network, learn about the spaces they’re

installed in and form logical groups.

BATTERY INSTALLATION

STEP 1:

Remove battery cover and install the two included CR123A

batteries in the orientation indicated by label on the

device.

STEP 2:

Replace battery cover.

SET UP NEW INSTALLATION

STEP 1:

Turn Conﬁguration Tool on using power button. Cree logo

is displayed when tool starts up. See Figure 2.

STEP 2:

Once ready, the Conﬁguration Tool will prompt to begin

OneButton™ Setup. Be sure to have all devices powered

on before beginning OneButton™ Setup. If other lighting

networks are found, select Set Up New to setup a new

installation.

STEP 3:

OneButton™ Setup will create a secure lighting network,

calibrate daylighting, and form luminaires and dimmers

into groups. The Conﬁguration Tool will display progress

throughout this process.

Step 4:

OneButton™ Setup is complete and your installation is

ready to use. Changes to groups and other settings can be

made from the Main Menu.

Front View

Bottom

View

USB (Mini B)

Port

Selection

LED

LCD Display

Keypad

Battery Compartment

Cancel/

Back

Device

Select

Power

Down

Summary of content (2 pages)

PAGE 1
Cree Configuration Tool With SmartCast™ Technology Wireless Configuration Tool Includes: CCT-CWC-1 INSTALLATION INSTRUCTIONS IMPORTANT SAFEGUARDS When using electrical equipment, basic safety precautions should always be followed including the following: READ AND FOLLOW ALL SAFETY INSTRUCTIONS 1. Caution: The batteries used in this device may present a fire or chemical burn hazard if mistreated. Do not recharge, disassemble, heat above 100°C (212°F) or dispose of in fire.
PAGE 2
3 MAIN MENU After starting the Configuration Tool and setting up a new installation or joining an existing installation, you will be brought to the Main Menu. See Figure 3. Modify Groups • Create new groups by selecting devices • Merge existing groups together • Add devices to an existing group • Ungroup an existing group Device Settings • Make changes to motion sensor settings, including timeout and occupied/unoccupied levels • Make changes to daylight harvesting settings.