Instruction Manual

2 of 6
LPN00861X0002A1_A
www.creelighting.com
© 2021 Cree Lighting, A company of IDEAL INDUSTRIES. All rights reserved. For informational purposes only. Content is
subject to change. See www.creelighting.com/warranty for warranty and specifications. Cree
®
and the Cree Lighting logo are
registered trademarks of Cree, Inc.
2
FIXTURE INSTALLATION – TWO CIRCUIT TRACK
STEP 1:
To install track fixture into lower circuit of two-circuit track, follow
directions for single circuit installation.
STEP 2:
To install track fixture into upper circuit of two-circuit track, raise the
Brass Contact labeled “P” by grasping Contact with needle nose pliers
and pulling up into position. See Figure 3.
STEP 3:
Insert Contact Support by tipping and positioning it under the “P”
Contact. See Figure 3. Snap Contact Support in place.
NOTE: Once the contact support is in place, make sure the “P” contact
is fully seated in the support by using the needle nose pliers to push the
“P” contact into place.
STEP 4:
Refer to instructions 1-3 under “Fixture Installation on Single Circuit
Track” section.
LENS REPLACEMENT
(CLEAR LENS INSTALLED)
STEP 1:
Before attempting Optical Lens Replacement, remove fixture from track.
STEP 2:
Remove front bezel. See Figure 4.
STEP 3:
Remove clear lens from bezel and replace with frosted lens.
STEP 4:
Push front bezel back into position. See Figure 5.
STEP 5:
Reinstall fixture onto track.
FCC NOTICE
CAUTION: Changes or modifications not expressly approved could void
your authority to use this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
CAN ICES-005 (A)/NMB-005 (A)
Indicator Arrows
Luminaire
Track Adapter
3
Contact
Support
Movable Brass
Contact “P”
4
5