Instruction Manual

ESSENTIA® SERIES
LED Track Head
S-CT-FB-B
1 of 6
LPN00861X0002A1_A
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D’INSTALLATION
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l’alimentation avant l’installation.
2. This luminaire must be installed in accordance with the NEC or your local electrical code. If you are not familiar with these codes and requirements,
consult a qualied electrician.
Ce produit doit être installé conformément à NEC ou votre code électrique local. Si vous n’êtes pas familier avec ces codes et ces exigences,
veuillez contacter un électricien qualié.
3. Min 90°C supply conductors.
Les fils d’alimentation 90°C min.
4. Wait until xture has cooled down before installing or servicing the xture.
5. Please read and understand all instructions thoroughly before installing any part of the Track system.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
NOTES:
• All E-conolight Track sections are manufactured with a Polarity Groove.
• All E-conolight Track fixtures are manufactured with Indicator Arrows designed to point toward the Polarity Groove once installed. See Figures 1-2.
• E-conolight Track fixtures are UL® Classified for use with E-conolight E-K1 and E-K2 Series, and Juno® (not affiliated with E-conolight) T and TU
Series track systems only.
• All E-conolight Track fixtures are supplied with a Contact Support to convert fixture from Single Circuit installation to Two Circuit Installation. See
Figure 3.
TO INSTALL:
FIXTURE INSTALLATION – SINGLE CIRCUIT
TRACK
STEP 1:
Insert Brass Contact on top of Track Adaptor into
the Track Channel. See Figures 1 and 3.
STEP 2:
Rotate the Track Adaptor 90° so that the Indicator
Arrows point toward the Polarity Groove once
installed. See Figure 2. Pull Adaptor Latch down
as you rotate Track Adaptor in order for Latch to
clear track edge and allow it to snap into place in
the track.
STEP 3:
To remove or relocate track fixture location, pull
Adaptor Latch down, rotate the Track Adaptor 90°
away from the Polarity Groove and remove.
1
Plastic
Insulator
Polarity
Groove
Copper
Conductors
Aluminum Track
Extrusion