Instruction Manual

CR Series
LED Architectural Troffer
Includes: CR14, CR24, CR22 1x4, 2x4, 2x2 Luminaires
LPN000053_K
1 of 2
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D’INSTALLATION
STEP 1:
Unpack the CR troffer from its shipping container.
STEP 2:
Install the (4) T-Bar clips included with the luminaire
(located in pre-pack fastened to luminaire J-Box). See
Figure 1.
STEP 3:
Place the CR troffer into the T-Bar Ceiling panel.
Ensure T-Bar clips are attached to the T-Bar. See
Figure 2.
EXPANDED JBOX ASSEMBLY OPTION:
In the case of through wiring with conductors larger
than 14 gauge, it is recommended to utilize the EJBCR-
5PK accessory to expand the junction box volume,
thereby allowing for additional space for wiring and
wiring fasteners. EJBCR-5PK is supplied separately
and attaches to existing J-Box assembly. It is sold in
minimum quantities of five.
TO INSTALL:
• The CR Series of recessed troffers is for non-insulated
ceiling applications using T-Bar ceiling grid, drywall grid
adaptors, and SMK-CR22 surface mount accessory kits.
• Designed for use in 120-277V 50-60 Hertz protected circuit
(fuse box, circuit breaker). Supply wire sized as per NEC or
governing code(s), 90C rated.
1
2
CR14
CR24
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be
followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l’alimentation avant l’installation.
2. This luminaire must be installed in accordance with the NEC or your local
electrical code. If you are not familiar with these codes and requirements,
consult a qualied electrician.
Ce produit doit être installé conformément à NEC ou votre code électrique
local. Si vous n’êtes pas familier avec ces codes et ces exigences, veuillez
contacter un électricien qualié.
3. Do not install insulation within 76 mm (3 in) of any part of the luminaire.
Ne pas mettre l’isolant à moins de 76 mm (3 po) de toute partie du luminaire.
4. Access above ceiling required.
Accès requis au-dessus du plafond.
5. Suitable for damp locations.
Convient aux emplacements humide.
6. Suitable for suspended ceilings.
Adaptee aux plafonds suspendus.
7. Do not handle energized module with wet hands or when standing on wet or damp surfaces,
or in water.
SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
CR22