Instructions

Document: Date
Created By:
LPN00706X0004A0_A 01-09-2023
TMT
INSTALLATION INSTRUCTIONS
C-ACC-D-FPAC
http://lighting.cree.com/warranty | 1-800-236-6800
6. Drive supplied expansion anchors into holes. See Figure 3.
7. Mount (2) cable support disks at the anchor locations using (6)
supplied Phillips screws. See Figure 4.
8. Lock cable couplers in place midway between hooks on cross
cables by inserting the supplied Allen screws into the bases of the
cable couplers and tightening loosely. See Figure 2.
9. Attach (4) retention hooks on ends of cross cables to (4) hanging
clips on xture. See Figure 5.
10. Fixture can be leveled by sliding cross cables to appropriate
balance point. Once xture has been leveled, tighten retention
screw to lock cable coupler in place.
11. To raise the height of the xture, pull the aircraft cable through the
hole in the cable coupler. See Figure 6.
To lower the xture, push down on the top of the cable coupler and
the aircraft cable will slide downward. Cut o󰀨 any excess cable
coming from the hole in the bottom of the cable coupler once the
desired length is achieved.
NOTE: It is recommended that at least 1" of cable remains below
bottom opening of cable coupler.
12. Remove screw on driver wiring chamber and remove cover. Set
screw and cover aside to be reinstalled later.
13. Make wiring connections in xture wiring chamber as detailed
in Fixture Wiring section of installation instructions included with
xture. Select the desired CCT and wattage using the dip switches
on the driver enclosure.
14. Reattach cover of wiring chamber with screw that was removed in
Step 12 above.
FIGURE 3
FIGURE 4
FIGURE 5
FIGURE 6
Hanging Clip
Retention Hook
Vertical Cable
Through Hole
Gripper
Retention
Screw
Insert Cable in
this Direction