Instructions

ManualsBrandsCREE LIGHTING ManualsLed LightingCree Lighting C-LITE C-ACC-D-FPAC LED Lighting

Document: Date

Created By:

LPN00706X0004A0_A 01-09-2023

TMT

INSTALLATION INSTRUCTIONS

C-ACC-D-FPAC

http://lighting.cree.com/warranty | 1-800-236-6800

CAUTIONS

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety

precautions should always be followed including the

following:

READ AND FOLLOW ALL SAFETY

INSTRUCTIONS

1. DANGER- Risk of shock- Disconnect power before installation.

DANGER – Risque de choc – Couper l’alimentation avant

l’installation.

2. CAUTION - Risk of Fire.

ATTENTION - Risque D’incendie

3. This xture must be installed in accordance with the nec or your

local electrical code. If you are not familiar with these codes and

requirements, consult a qualied electrician.

Ce produit doit être installé conformément à nec ou votre code

électrique local. Si vous n’êtes pas familier avec ces codes et ces

exigences, veuillez contacter un électricien qualié.

4. Suitable for damp locations.

Convient aux emplacements humides.

5. ACCESS ABOVE CEILING REQUIRED.

ACCES REQUIS AU-DESSUS DU PLAFOND.

6. INHERENTLY PROTECTED.

PROTECTION INHERENTE.

7. TYPE IC. Vapor barrier must be suitable for 90°C.

TYPE IC. Le pare-vapeur doit convenir pour 90°C.

8. FOR USE IN NON-FIRE RATED INSTALLATIONS ONLY.

UTILISER SEULEMENT DANS DES INSTALLATIONS OÙ LE

DEGRÉ DE RÉSISTANCE AU FEU N’EST PAS ÉTABLI.

9. NO USER SERVICEABLE PARTS.

PIECES NON REPARABLES PAR L’UTILISATEUR.

SAVE THESE INSTRUCTIONS FOR

FUTURE REFERENCE

1. Bend (4) hanging clips on xture into a vertical position. See

Figure 1.

2. Locate desired xture location on mounting surface.

NOTE: Make sure power is available at chosen location.

3. Mark attachment locations for aircraft cable on mounting surface.

NOTE: Spacing distances between attachment points for aircraft

cable are as follows:

• 2'x2' xture: 12-7/8"

• 1'x4' xture: 35-3/16"

• 2'x4' xture: 36-1/2"

4. Use the cable support disks as a template to mark screw locations

for mounting the support disks. Three screws are used for each

support disk. See Figure 2.

5. Use 1/4" drywall drill bit to drill holes for expansion anchors at

marked locations.

INSTALLATION

FIGURE 1

FIGURE 2

Hanging Clips

Aircraft Cable

Retention Hook

Engaged with

Hanging Clip

Cross Cables

Cable Coupler

Cable Support Disk

Phillips Screw

Allen Screw

Allen Wrench

Cable Coupler

Ceiling

Summary of content (6 pages)

PAGE 1
INSTALLATION INSTRUCTIONS C-ACC-D-FPAC LPN00706X0004A0_A TMT Document: Created By: 01-09-2023 Date INSTALLATION 1. CAUTIONS 2. 3. IMPORTANT SAFEGUARDS When using electrical equipment, basic safety precautions should always be followed including the following: READ AND FOLLOW ALL SAFETY INSTRUCTIONS 1. 2. 3. 4. 5. 6. 7. 8. 9. DANGER- Risk of shock- Disconnect power before installation. DANGER – Risque de choc – Couper l’alimentation avant l’installation. CAUTION - Risk of Fire.
PAGE 2
INSTALLATION INSTRUCTIONS C-ACC-D-FPAC Document: Created By: LPN00706X0004A0_A TMT Date 01-09-2023 FIGURE 4 6. 7. 8. 9. 10. 11. 12. 13. 14. Drive supplied expansion anchors into holes. See Figure 3. Mount (2) cable support disks at the anchor locations using (6) supplied Phillips screws. See Figure 4. Lock cable couplers in place midway between hooks on cross cables by inserting the supplied Allen screws into the bases of the cable couplers and tightening loosely. See Figure 2.
PAGE 3
INSTRUCCIONES DE INSTALACIÓN C-ACC-D-FPAC Documento: Creado por: LPN00706X0004A0_A TMT Fecha 09-01-2023 INSTALACIÓN 1. PRECAUCIONES 2. MEDIDAS DE SEGURIDAD IMPORTANTES Al usar aparatos eléctricos, siempre deben seguirse ciertas medidas básicas de seguridad, incluidas las siguientes: 3. LEA Y SIGA TODAS LAS INSTRUCCIONES DE SEGURIDAD 1. 2. 3. 4. 5. 6. 7. 8. 9. PELIGRO- Riesgo de descarga eléctrica. Desconecte la alimentación eléctrica antes de la instalación.
PAGE 4
INSTRUCCIONES DE INSTALACIÓN C-ACC-D-FPAC Documento: Creado por: LPN00706X0004A0_A TMT Fecha 09-01-2023 FIGURA 4 6. 7. 8. 9. 10. 11. 12. 13. 14. Introduzca en los orificios los anclajes expansivos suministrados. Consulte la Figura 3. Instale los (2) discos de soporte del cable en las ubicaciones de los anclajes usando los (6) tornillos de cabeza Phillips suministrados. Consulte la Figura 4.
PAGE 5
INSTRUCTIONS D’INSTALLATION C-ACC-D-FPAC Document : Créé par : LPN00706X0004A0_A TMT Date 09-01-2023 INSTALLATION 1. MISES EN GARDE 2. MESURES DE SÉCURITÉ IMPORTANTES 3. Lors de toute utilisation d’appareils électriques, les consignes de sécurité de base doivent toujours être respectées, dont les suivantes : Pliez les (4) attaches de suspension sur le luminaire en position verticale. Voir Figure 1. Localisez l’emplacement désiré du luminaire sur la surface de montage.
PAGE 6
INSTRUCTIONS D’INSTALLATION C-ACC-D-FPAC Document : Créé par : LPN00706X0004A0_A TMT Date 09-01-2023 FIGURE 4 6. 7. 8. 9. 10. 11. 12. 13. 14. Enfoncez les ancrages extensibles fournis dans les trous. Voir Figure 3. Installez les (2) disques de support de câble aux emplacements d'ancrage à l'aide des (6) vis cruciformes fournies. Voir Figure 4.