Instruction Manual
1 of 1 LPN000143_C
www.cree.com/lighting
INSTALLATION INSTRUCTIONS
PW-18/4-06-9T/SS
6' Flexible Power Whip
© 2015 Cree, Inc. All rights reserved. For informational purposes only. Content is subject to change. See
www.cree.com/lighting/products/warranty for warranty and specifications. Cree® and the Cree logo are
registered trademarks of Cree, Inc.
TO INSTALL:
1
2
3
STEP 1:
Remove the existing junction box cover and properly dispose
of it. Set the screw aside to reinstall later. See Figure 1.
STEP 2:
Locate the lever nuts on the power whip and connect
corresponding color troffer leads by lifting up the lever. See
Figure 2.
STEP 3:
Carefully insert leads and lever nuts into junction box
compartment. Complete by installing the new supplied
junction box cover on the whip and secure with retained screw
removed in Step 1. See Figure 3.
STEP 4:
Refer to luminaire installation sheet to complete install.
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l’alimentation avant l’installation.
2. This luminaire must be installed in accordance with the NEC or your local electrical code. If you are not familiar with these codes
and requirements, consult a qualied electrician.
Ce produit doit être installé conformément à NEC ou votre code électrique local. Si vous n’êtes pas familier avec ces codes et ces
exigences, veuillez contacter un électricien qualié.
3. Check to make sure that all xture connections have been properly made and the xture is grounded to avoid potential electrical
shocks.
4. Do not handle energized xture when hands are wet, when standing on wet or damp surfaces, or in water.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE