Installation Sheet

1 of 2
TO INSTALL:
RECESSED HOUSING COMPATIBILITY
Designed to install in standard 4in recessed downlight
housings.
Compatible with most dimmers when used with multiple
fixtures. Consult www.creebulb.com/dimmers for a
compatibility chart.
•
•
• Compatibility of housings may be determined by
measurement of the housing as detailed in the drawing
above (Figure 1).
Minimum distance
between edge of
fixture and top of
housing or other
obstruction.
1
2
IMPORTANT SAFEGUARDS
WARNING
circuit breaker before installing or servicing.
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. WARNING – Risk of fire or electric shock. LED Retrofit Kit
installation requires knowledge of luminaires electrical
systems. If not qualified, do not attempt installation. Contact a
qualified electrician.
2. WARNING – To prevent wiring damage or abrasion, do not
expose wiring to edges of sheet metal or other sharp objects.
3. WARNING – Risk of fire or electric shock. Install this kit only
in the luminaires that have the construction features and
dimensions shown in the photographs
and/or drawings
where
the input rating of the retrofit kit does not exceed the input rating
of the luminaire.
SUITABLE FOR TYPE IC LUMINAIRES.
5.
4.
It may be necessary to remove a socket mounting plate for
adequate clearance.
6. E
ach lampholder shall be installed only in its intended manner
and orientation.
7. Suitable for Wet Locations.
8. Min. temperature rating of -25°C.
9. D
11.
12.
10. SUITABLE FOR INSTALLATION IN A RECESSED CAN WITH A
MAXIMUM OF EIGHT (8) No. 12 AWG THROUGH-BRANCH CIRCUIT
CONDUCTORS SUITABLE FOR 75°C MIN.
WARNING-THIS RETROFIT KIT IS ACCEPTED AS A COMPONENT
OF A LUMINAIRE WHERE THE SUITABILITY OF THE COMBINATION
SHALL BE DETERMINED BY AUTHORITIES HAVING JURISDICTION.
MIN. LAMP COMPARTMENT DIMENSIONS
4 inch/101.6mm (DIA) x 5 inch/127mm (H).
o not make or alter any open holes in an enclosure of wiring or
electrical components during kit installation.
SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
TRDL4 Series
4” Recessed LED Downlight
STEP 1:
Carefully rotate the“Flip Clips”clockwise
until the clips are fully-deployed. See
Figure 2.
STEP 2:
Make sure the POWER IS TURNED OFF at
the source to the recessed can.
STEP 3:
Remove existing trim and bulb, revealing
the
Install "Field Applied Label" into the
recessed can.
existing recessed socket.
STEP 5:
STEP 4:
Screw the fixture Edison base assembly
into the recessed can socket by turning
clockwise. See Figure 3.
STEP 6:
Install fixture up into the recessed housing
firmly until trim ring is flush with the
ceiling. Rotate fixture clockwise slightly to
tighten fit with ceiling and set in recessed
clips inside of recessed housing during
installation. See Figure 3 and 4.
3
Flip Clip
4 inch
(101.6mm)
5 inch
(127mm)
5.5 inch
(140mm)
LPN000240 REV B
pilF“erusne ,stluser tseb roF .gnisuoh
mirt latem htiw dengila ton era”spilC
Package Contents:
Part Description Quantity
A 4” Retrofit downlight
1
B Edison Socket Adapter
C Field applied label
1
1
A
B
This device is not intended for use with emergency exit fixtures or
emergency exit lights.