FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 1 INSTRUCTIONS for INSTALLATION and USE Gas Hob W810 This appliance must be installed in accordance with regulations in force and only in a well ventilated place. Ensure that the hob unit is securely fixed to the worktop before use. To the Installer Before installation fill in the product details on the back cover of this booklet. The information can be found on the rating plate.
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 2 CONTENTS Introduction For Your Safety – Always For Your Safety – Never 3 4 5 Using The Hob 6 Care & Cleaning Something Wrong? 7 8 Installation Key contacts Retention of this Instruction Book 9 - 14 Back Cover This Instruction Book must be kept handy for reference as it contains important details on the safe and proper use of the appliance.
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 3 INTRODUCTION Your new hob is guaranteed* and will give lasting service. This guarantee is only applicable if the appliance has been installed in accordance with the installation instructions detailed in this booklet. To help make best use of your cooking equipment, please read this booklet carefully. The hob is designed specifically for domestic use and responsibility will not be accepted for use in any other installation.
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 4 FOR YOUR SAFETY When used properly, your appliance is completely safe but as with any product there are certain precautions that must be observed. PLEASE READ THE PRECAUTIONS BELOW BEFORE USING YOUR APPLIANCE. ALWAYS ● ● ● ● ● ● ● ● ● ● ● Always make sure you understand the controls prior to using the appliance. Always keep children away from the appliance when in use as the surfaces will get extremely hot during and after cooking.
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 5 FOR YOUR SAFETY NEVER ● ● ● ● ● ● ● ● ● ● ● ● ● Never leave children unsupervised where a cooking appliance is installed as all cooking surfaces will be hot during and after use. Never allow anyone to sit or stand on any part of the appliance. Never store items above the appliance that children may attempt to reach. Never leave anything on the hob surface when unattended and not in use.
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 6 USING THE GAS HOB - FEATURES In order to obtain maximum performance from the burners, use pans with the following diameters: Rapid burner 22 - 28 cm Standard burner 14 - 22 cm Auxillary burner 10 - 14 cm All pans should be positioned centrally over the burners. DO NOT allow young children near to the appliance when the hob is in use as the surfaces get extremely hot.
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 7 CARE AND CLEANING SWITCH OFF THE ELECTRICITY SUPPLY BEFORE CLEANING. BEFORE SWITCHING ON AGAIN, ENSURE THAT ALL CONTROLS ARE IN THE OFF POSITION. NEVER USE BIOLOGICAL WASHING POWDER, HARSH ABRASIVES, SCOURING PADS, AEROSOL CLEANERS OR OVEN CHEMICAL CLEANERS OF ANY KIND. Clean the hob regularly and wipe up spills soon after they occur to prevent them from becoming burnt on. CLEANING MATERIALS TO AVOID 1. Household abrasive powders, e.g. Vim. 2.
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 8 SOMETHING WRONG ? IF THE IGNITION DOES NOT WORK Is the electricity switched on? If the electricity supply has failed, the burners can be lit with a match. If only a hotplate burner is failing to ignite, check that the burner body and cap are seated correctly and that the slots in the burner body are not blocked (see care and cleaning). May we wish you many years of carefree successful cooking.
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 9 INSTALLATION - electrical requirements WARNING – THIS APPLIANCE MUST BE EARTHED. CONNECT TO A 230-240V A.C. SUPPLY ONLY. Connection to the electricity supply should be made via a properly earthed, readily accessible wall socket which is adjacent to but not directly above, and not more than 1.25m away from the appliance and capable of electrical isolation.
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 10 INSTALLATION INSTRUCTIONS Gas Category II2H3+ (GB,IE) Model Numbers W810, BG05 These models are set to burn NATURAL GAS (G20) at 20mbar. They can also be converted to burn BUTANE GAS (G30) at 28mbar or PROPANE GAS (G31) at 37mbar using the conversion kit included. Technical Data Gas Connection Rp 1/4 (1/4” BSP female) Pressure test point Burner injector Gas rate adjustment None Aeration adjustment None Electrical Connection 230-240V ac.
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 11 INSTALLATION INSTRUCTIONS Prior to installation, ensure that the local distributions (nature of the gas and gas pressure) and the adjustment conditions are compatible. The adjustment conditions for this appliance are stated on the rating plate which is fitted on the underside of the base panel. This appliance is not designed to be connected to a combustion products evacuation device.
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 12 INSTALLATION SITING THE HOB The hob is designed to fit into worktop and base unit(s) with a cutout as shown in Fig.1. Any obstruction such as supports or side panels must be removed to allow 30mm minimum depth below the worktop cutout. Any overhead surface of combustible material must not be closer than 600mm.
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 13 INSTALLATION Fig. 1 IMPORTANT Minimum unobstructed depth 30mm 558 mm 50mm mm 489 Front edge of worktop Worktop thickness Preferred 30-40mm 19mm minimum recommended Fig. 2 FIXING CLAMP Note: Do not over tighten the hob clamps as distortion of the hob may occur.
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 14 INSTALLATION INSTRUCTIONS LPG Conversion Instructions for Model W810, BG05 Read the Gas Hob instructions before conversion, installation and using the Gas Hob.
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 15 15
FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 16 Key Contacts Service Creda has the largest appliance manufacturer’s service team in Europe, trained specialists directly employed by us to ensure your complete confidence. Repair Service UK: 08709 066 066 Republic of Ireland: 1850 302 200 You will be asked for the following information:Name, address and postcode.
