Technical data

22
Installation Instructions
After installation, check for gas soundness. The supply pressure can be
checked at the grill injector. Access to the injector is by first removing
the rear panel at the back of the splashback. Then remove the fastening
screw and slide the burner off the injector.
Fit the battery. Fit the hotplate burner bodies, enamelled discs and pan
supports. Referring to the instructions for use where necessary.
1. Check that the hotplate and grill burners ignite correctly and
burn with a steady flame. Check for a steady flame on the low
setting.
2. Check that with the oven set to mark 9, the burner ignites at low rate,
and then increases to full rate within 60 seconds.
Leave the oven full on with the door closed for 10 minutes, and
check that when the control is turned to the ‘Slow Cook’ setting that
the flame reduces.
Instruct the user on the operation of the cooker.
Operational
Checks