Programming instructions

A few recommendations:
Read the instructions before installing the device.
Isolate from the mains before working on it, and check the power supply voltage.
Store the instructions,even after installing the device.
Characteristics of the device:(shown on therating label)
IP24:Device protected against water projections. Class II :
Double insulation.
INSTALLING THE DEVICE
1) Location of the device
- This device was designed to be installed in residential
premises.In any other case, please call your distributor.
- Installation must be ensured according to the
wiring rules
and in compliance with the standards currently
enforced in the country
of installation.
Locate the device beyond
ªIn a draught likely to upset its regulation
minimum distances from .
Do not install the device:
ªIn a dra
ught likely to upset its regulation
ªUnder a fixed mains outlet.
ªInside zone 1 in bathrooms.
ªInside zone 2 if the controls are accessible to persons using the shower or
the bath tub.
2) How to install the device
1)Position according to the diagrams below:
Zone
3
Zone
2
60 cm
60 cm
60 cm
3 m
2,25 m
Zone
1
Control
unit
15 cm min
20 cm min
15 cm min
15 cm min
20 cm min
15 cm min
Antidust
filter
The fan is fitted with an antidust filter which,when
clogged,can result in its stoppage (red indicator lit
on the device).
For better use,clean your filter regularly,according
to the following instructions.
1.Power off the device.
4.Refit the filter.
5.Wait 10 minutes before restarting the device.
3.Clean the filter.
2.Extract the filter from the back of the machine.
These instructions are shown on the fan in the following form:
ON/OFF switch
Red indicator
Part to clean
Model fitted with a fan
Version
Power
(W)
Height with
control box
(mm)
Width
(mm)
OUTLINE
500W 656 400
750W 1066 400
SKYLINE
600W 984 470
750W 1035 470
Outline
Skyline
obstac
l
es