Specifications

Security and surveillance
Digital video recorders (DVRs)
120 Maxim Industrial Solutions
Recommended solutions
Part Description Features Benefits
Video codec
MG3500 H.264 video codec SoC Video formats: HD 1080p30 H.264 codec, MJPEG
codec; audio formats: AAC, AMR, Dolby
®
, G.7xx,
MP1/2/3; HD MPEG-2 decoder, 4 D1 + 4 CIF H.264
encoders or 8 D1 H.264 decoders
Superb video-quality recordings at any resolution
for improved identification; complete development
environment drastically reduces time to market
Video decoder
MAX9526 Low-power, high-performance NTSC/
PAL video decoder
Supports all NTSC and PAL standards; true 10-bit
digital processing; 2:1 video input mux
Superior video quality provides improved
identification; configuration method speeds design
time
Video amplifiers
MAX9652–54 3.3V, HD/SD triple-channel filter
amplifiers with shutdown
2V/V gain; 42MHz passband for HD with 50dB
attenuation at 109MHz
Allow design flexibility where switchable HD/SD
operation is required; shutdown mode saves power
MAX9586–89 Single/dual/triple/quad, SD video
filter amplifiers with AC-coupled input
buffers
Low power; small size; 8.5MHz passband; 55dB
attenuation at 27MHz
Integrated solution saves PCB area
MAX9507 1.8V, DirectDrive
®
video filter
amplifier with load detection and dual
SPST analog switches
Dual SPST analog switches controlled through I
2
C
interface; DirectDrive sets video-output level near
ground; internal gain of 8V/V; load detection and
reporting
Integrated switching functionality simplifies design;
DirectDrive eliminates output capacitance, thus
reducing cost and saving space
Audio codec/DAC
MAX9860 16-bit audio voice codec Ultra-low power, mono codec; programmable digital
filter
Complete audio solution saves development time
Power ICs
MAX8654 Step-down switching regulator 25mΩ R
ON
; 8A internal switch; 4.5V to 14V input;
6mm x 6mm, 36-pin TQFN
Reduces space requirements when implementing
power supplies requiring a high-current output
MAX15035 Step-down regulator Fully integrated; 4V to 26V Compact solution for small form-factor applications
MAX1970 Dual step-down converter 2.6V to 5.5V input; 750mA output current; power-on
reset (POR); 180° out-of-phase operation
Saves space by reducing input capacitance
USB ESD-protection IC
MAX4987 Overvoltage-protection controller with
USB ESD protection
Integrated low-R
ON
(100mΩ) nFET switch; overcurrent
protection (autoretry); 1.5A (min) internal overcurrent
protection
Provides ESD protection for Hi-Speed USB I/O,
increasing system reliability
USB current-limited switch
MAX8586 USB current-limit switch 3mm x 3mm; 2.7V to 5.5V; 20ms fault blanking Protects against power faults, increasing system
reliability while saving space
FPGA authenticators
DS28E01-02 1-Wire
®
SHA-1 bidirectional
authenticator with 1Kb of EEPROM
Single, dedicated contact operation; SHA-1 secure
authentication and data protection; 1Kb of EEPROM
Crypto-secure to prevent copying of FPGA design;
single FPGA I/O pin for operation
DS28E10* 1-Wire SHA-1 authenticator with 224b of
one-time programmable (OTP) EPROM
Single-contact operation; unidirectional SHA-1
authentication
Lowest cost solution for SHA-1 authenticator
(Continued on next page)
* Future product—contact factory for availability.