User manual

1-2 INTRODUCTION

Special Features

•

Fax Transmission and Reception at up to 14 400 bps

• Automatic recall of Stored Telephone Numbers, with

• Password Protection

• Remote Conﬁguration

• Number Storage for 20 Telephone Numbers

• Voice Mode for Onward Transfer of Voice

• Information (Option)

• Compression/Decompression of digitized speech

General Description

•

Synchronous or Asynchronous

• Auto-protocol: the Modem adjusts automatically to all Full Duplex Trans-

mission Protocols and Speeds

• MNP 5 and V.42bis Data Compression and Error Correction

• MNP 10; specially useful in association with Radio Telephones

• Max. 57 600 bps Active Transmission Rate (V.32bis with V.42bis)

• Automatic Baud Rate Recognition at all Speeds up to 57 600 bps in Hayes Mode

• Automatic Dialling with Hayes AT Command Set or with V.25bis

• Automatic Recall with Password Protection

• Remote Conﬁguration is possible over Telephone Line

Installation Instructions

1. Use the interface cable supplied to connect the modem to a free COM inter-

face on the computer

2. Use the telephone cable supplied to connect the modem to a Telephone jack

3. Use the mains cable supplied to connect the modem to a power socket

(220-240 VAC)

4. When the “POWER” LED is lit, the modem is ready for operation and will

provide data communication, using the factory settings which have been in-

stalled

5. Conﬁgure the modem with the communications software or fax software to

meet your requirements

➮ Voice Mode is available only with the appropriate Accessory Pack