User manual

5-14 S-REGISTERS
S86 – Error Codes for NO CARRIER Messages
For every NO CARRIER message a value is written into this Register, which as-
sists in discovering the cause of the error. In each case, the initial cause of the NO
CARRIER message is recorded.
S86=0 Normal break of connection; no error
S86=4 Loss of carrier
S86=5 Remote modem has no V.42 capabilities
S86=9 No common protocol possible with remote modem
S86=12 Normal break of connection, initiated by remote modem
S86=13 Remote modem has not reacted after the 10th repeat of the same
information
S86=14 Protocol error
S95 – Extended Connection Messages
This Register can be used to render various W-command settings inactive. With
the bits listed below, the value 1 will allow the messages described, no matter what
the W-command setting may be.
Bit 0 CONNECT message gives the modem speed
Bit 1 CONNECT XXXX REL messages for connections with Error cor-
rection (factory setting)
Bit 2 CARRIER XXXX connection messages authorised
Bit 3 PROTOCOL XXXX connection messages authorised
Bit 4 Reserved
Bit 5 COMPRESSION XXXX connection messages authorised
Bit 6,7 Reserved